• Your position
  • Sign In or Join Free
Your position: Home / Main products / Expansion board

NEW! keyestudio RS232 to TTL Conversion Shield Compatible with Arduino

    Please select the information you wantX
(991 available)
Shipping Cost:
Estimated Delivery Time:
Please select the country you want to ship from
  • Description
  • Reviews
The RS232 to TTL conversion shield is specially designed for UNO R3 control board, very convenient to change the serial port into RS232 interface.
The shield comes with a DB9 connector(male head), easy to connect various RS232 interface equipment. It also comes with a RS232 pin header for connection and debugging.
It even comes with soldering area for DIY design, so you can make full use of this shield. On the shield there is a programming mode control switch; turn OFF for burning the program to UNO R3; turn ON for normal use.
Technical Details
  1. Power supply: DC 5V
  2. Comes with 16 digital IO pins(with an I2C pin)
  3. Comes with 6 analog IO and power
  4. Comes with a run/programming switch
  5. Comes with transmitting, receiving indicator and D13 indicator
  6. DB9 connector(male head)、RS232 pin headers
  7. Soldering ares
  8. Comes with a Reset button
  9. Dimensions: 60*53.4MM
  10. Environmental properties: ROHS
Interface Explanation

Hookup Guide

Test Code
int led = 13;    // define LED pin
void setup()
  Serial.begin(9600);    //initialize the serial port
void loop()
  int temp;    //temporary cache of serial data
  if(Serial.available())    //if serial port receives the data
    temp=Serial.read();    //save the received data
      digitalWrite(led,1-digitalRead(led));    //if received data is the characterV, change the LED state.
    Serial.println("OK");    //reply OKmeans that the characterV has been received and the LED state changed
Test Result
Stack the shield onto UNO R3 board, and connect the UNO R3 control board to your computer using a USB cable. Then connect the shield with RS232 serial port cable. Turn the switch OFF, begin to burn the test program.
Programmed success, turn the switch ON, and open the serial debugging tool, select the proper Port COM1 (note the baud rate should set to 9600).
Data sending window will show “V” , and receiving window will show “OK”. You should see the built-in TX1 and RXD indicator flashing on. Each time send the “V”, onboard L light turns on, send again, the L light will turn off, repeatedly.

Average rating:
Share your thoughts with other customers
Write a review
Product reviews can be carried out after the member login, please click here to login
Kit for Arduino
Robot for Arduino
Raspberry Pi
Overseas Clearance Sale
Ship to EU
Ship to US
Ship to CA
New Arrivals
Main products
Controller board
Expansion board
Learning kit
Robot KIT
Easy-plug RJ11 series
Easy-plug Learning Kit
Easy-plug Sensor