Keyestudio W5500 network shield comes with W5500 network module as core.
It can make as simple Web server, or write and read the High/Low level of digital pins, or analog value of analog pins via network control.
It is compatible with both keyestudio UNO R3 and Mega 2560 R3 development board.
When using, stack the W5500 shield onto UNO board, and upload the program to control board, which can make a simple Web server.
You can quickly make your controller access to internet to build your network application.
At the same time, it also supports mini SD card(TF card, maximum storage 1G) read and write.
You can direct stack the W5500 Network shield onto control board, or stack other expansion boards on this Network shield.
The shield has four 3mm fixing holes, easy to mount on any other devices.
Technical Parameters
Input voltage: DC 5V
Working voltage: DC 3.3V
Working current: about 380mA
Maximum power: 3W
Working temperature: -55℃ ~ +75℃
Network transformer interface type: RJ-45
Female header pitch: 2.54mm
mini SD card/TF card storage: Maximum 1G
TF socket: self-popping
Fixed hole diameter: 3mm
Dimensions: 65mm*50mm*27mm
Weight: 25g W5500 full hardware TCP/IP protocol stack network chip
Support high speed SPI bus (SPI mode 0, 3);
Support hardware TCP/IP protocol: TCP, UDP, ICMP, IPv4ARP, IGMP, PPPoE;
Embedded 10/100Mbps Ethernet physical layer;
Support auto answer (full duplex / half duplex mode);
Multiple indicator signal outputs (full/half duplex);
Support 8 independent ports to connect at the same time;
Internal 32K byte memory for TX/RX buffer;
Support sleep mode and network wake-up;
3.3V working voltage, I/O port can withstand 5V voltage
USD
EUR
GBP
CAD
AUD